Modeling Drafting and CAM

Injection Top

	To successfully design an effective manufacturing process, we often adjust the CAD data from our customer.
To reduce mistakes in the design process, we establish a 3-dimensional design process by using solid, assembly technology.
	Using a 3-dimensional process, we can easily design parts that can slide in an inclined direction.
Many 2D and 3D machining cutter paths are defined and calculated.
	By using some simulation software like Vericut or NC-Verify, we make sure that all NC data runs correctly. After that, each set of NC data is supplied to the target machining-center by DNC system (NGK original).

INJECTION TOP